Veris-industries USB to DIC Converter Install Manuale Utente

USB to DIC ConverterInstallation Data941700-0043-EN (May 2012)Rev. 2ConverterLegacy Device

SOFTWARE CONFIGURATIONPrior to using the DIC product software, the proper communications (COM) port number must be established. 1. Open the Device Ma

3. Open the “DataIndustrial.exe” le from Step 2 of the “Badger Meter DIC Product Software Installation” on page 5. The Badger Meter DIC Product Sof

Please see our website at www.badgermeter.com for specific contacts.www.badgermeter.comData Industrial is a registered trademark of Badger Meter, In

USB to DIC ConverterPage ii May 2012

CONTENTSINTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5I

USB to DIC ConverterPage iv May 2012

INTRODUCTIONThe USB to DIC (Data Industrial Corporation) Converter facilitates the connection of legacy (RS-232) devices to the more modern USB-equipp

4. When prompted about the Windows Update driver installation, select “Yes, this time only,” then click Next.

6. If the computer is running a pre-XP version of a Windows operating system or cannot connect to the Internet, use a newer, Internet-connected compu

9. Using Windows Explorer, navigate to the FTDI driver package, then right-click on the zip le to extract the les.10. Check the boxes labeled “Sea

Figure 7: Finish the Driver Installation14. An additional driver installation prompt may appear requesting the installation of a “USB Serial Port” d